Pen tool does not always register
-
This has been brought up in the forum before but it continues to occur. The pen tool does not always register and does not always maintain a single path - it does not always start properly - a thin line shows up and disappears and at other points in the path, the line stops being connected. I also noticed the image used for reference has some jitters to it as I use the pen tool - not sure if it is at all related
here is a video of this issue -
@Boldline Yes, this issue is still open. Could not replicate so far, but will try again.
-
@vectoradmin Is there anything I can do when it occurs to help? Typically I go back a step and have you repeat the order of things that caused the bug, but that seems harder with this issue
-
@Boldline I think the best so far is just to have the recording. I will try to do the same steps.
