Node scaling not working/intermittent
-
@debraspicher I could not replicate this using similar steps.
When the node sizes return to small, does the setting value also show 100% ?
-
@debraspicher Got to the workspace files folder (Help -> Reveal Workspace Folder) and send me those files by email (contains settings and workspace info).
I can check if the setting was saved correctly, and if there might be something else interfering with it.
-
@VectorStyler No, it was still set at 125% where I had left it a while ago to try. I only noticed it wasn't taking when I had issues accessing nodes and control points (as I typically do at this scale).
WP files:
https://1drv.ms/u/s!AuWHX0h5bAoRiptsp_pr-kuekYgxzw?e=Gfd9W4 -
@debraspicher Got it, I will try to replicate this.
-
I noticed that when moving UI-upscaled Nodes, it doesn't change scale immediately. When I run any kind of material operation, like Undo, Join curves, etc, then it causes the nodes to reduce back to the smaller size. It's not preserved though when I restart the program, so I have to go back to Preferences and "resubmit" the larger scale option again. (no change to the field value, just hit OK in Preferences on the Path Editor page).
-
Another quirk: When swapping to Anchor Point tool, the points will "rescale" back to the original setting in Preferences (125% in this case). Going back to the Node tool immediately lowers them again:
Video: https://1drv.ms/u/s!AuWHX0h5bAoRipw2lfdHHcQAeV0o6w?e=trvgZ6
-
@debraspicher said in Node scaling not working/intermittent:
When swapping to Anchor Point tool, the points will "rescale" back to the original setting in Preferences (125% in this case). Going back to the Node tool immediately lowers them again
This narrows down a bit the cause, I will try to replicate it.
-
I just opened a document in 1.2.039. Looks like this is fixed! I immediately noticed my nodes are larger. In fact, I may need to lower them back down in scale. 100% may be "just right" now.
-
@debraspicher said in Node scaling not working/intermittent:
In fact, I may need to lower them back down in scale. 100% may be "just right" now.
Now it is also using the display scaling factor from the system settings
-
@VectorStyler Yes, I think that is perfect. Thank you!
